Fully compatible with IMPULSE®•Link 5 software and DataLogger Series 4 (DLS4), MagnePulse DMC Series 2 provides critical performance information, such as alarm, fault, and run details, and can assist with predictive maintenance and minimize downtime. Comprehensive software offers flexible programming with quick parameter changes as conditions require.
Designed with safety in mind, the MagnePulse DMC Series 2 monitors itself while in use and can be programmed to maintain safe thresholds of the magnet it is controlling, including twentyfive variables such as magnet current, voltage, resistance, temperature, and DC-bus voltage. Its power loss ride-through feature keeps the magnet energized during power interruptions, ensuring loads are not dropped. MagnePulse also features built-in software that automatically cuts power to the drive during a fault event, preventing damage to the magnet and the drive itself.
Digital control of the magnet’s demagnetizing current allows the magnet to clean the load faster and more consistently, helping to increase facility throughput. MagnePulse helps reduce lifting current while allowing the magnet to maintain a full load. This saves energy and increases the average lift capacity of each magnet for improved productivity. The OmniBeam™ feature allows you to enable any combination of up to 10 magnets to precisely match individual load requirements.
Efficient energy use reduces magnet heating up to 50%, minimizing the need for magnet changeouts. Over-temperature protection utilizes the magnet’s resistance to determine its temperature, preventing magnet damage and increasing life expectancy.
Control options include single-input, dual-input, stepped-input, analog, or serial current references, as well as a programmable input to maximize magnet and crane performance. MagnePulse DMC Series 2 can be retrofitted for your current system, designed as a pre-engineered panel, or be added to a custom panel built to your exact specifications.
CONTINUOUS CURRENT RATING